Install the sub-support (
model MJ10-1300E / MJ10-1600E
)
1. Attach the front sub-support to saw base unit and Tight it with 4-M8x25 allen screws w/spring
washers.
2. Attach the front sub-support to main saw base on same way.
2. Align the front sub-support. Rear sub-support and the main saw base on the same level.
Install the main blade elevation & angle handwheel
1. Fitting the elevation handwheel(
1
) and angle handwheel (
2
) onto the elevation and angle shaft.
3.
Screw the blade lock knob(3) onto the elevation handwheel.
Install the swing arm assembly
1 .Place 4 M8x30 hex head screws to mount the swing arm assembly to the saw base unit, and keep the
arm on horizontal level.
2 .Place the cross-cut table support (A) onto the swing arm assembly, and hand tighten the lock nuts.