Jetter JetMove D203, User Manual

Page: 24 / 142

2 Installation of the JetMove D203
24 Jetter AG
2.2 Mechanical Installation
Prior to installing the digital servo amplifier check it for possible
transport damages.
Please check the shipment for completeness.
To ensure proper functioning of the JetMove D203, check whether the
mounting plate in the electric cabinet is unpainted.
The only possible mounting position is vertical - see fig. 4, page 25.
Please make sure there is a clearance of at least 100 mm under and
above the JetMove D203 - unobstructed ventilation must be granted.
Please mark on the panel two positions for the fastening screw threads
of the JetMove D203 (see fig. 4, page 25).
Drill the holes and cut the female threads into the mounting plate.
Screw the corresponding fitting screws into the thread by approximately
half of their length.
By means of the oblong holes in the rear plate, hang up the JetMove
D203 by the fitting bolts; then screw them tightly.