Tang-Side
Up
Wood
Figure 09
Figure 10
2. Safety Instruction:
Please read the safety instruction and
operation instruction carefully.
Please do wear a safety glass to avoid
any material from coming into the eyes
whilst operation.
Please do wear ear mufflers or earplugs
to avoid any noise from hurting the
listening whilst operation.
Please do wear proper work clothing
whilst operation. Loose clothing or tie are
prohibited to avoid any unnecessary
incident.
If a operator has long hair, please do fix
the hair or use cap to avoid the hair from
being drawn into it.
A processing workpiece shall be fixed
firmly to avoid it from being thrown out
whilst operation.
Please keep both hands far from the
rotating tool whilst operation. Cotton
gloves are prohibited to avoid from being
drawn into cutter.
Please pull out the power plug to avoid
any electric shock incident whilst product
maintenance or repair.
1. Make sure the power voltage is for the machine.
Before connecting the plug to socket, it is necessary
to check the power spec. to avoid any damage
occurring.
2.
If the machine is not used for a long time, the plug
should be disconnected.
WARNING
Electrocution or fire could result
if machine is not grounded and
installed in compliance with
electrical codes. Compliance
MUST be verified by a qualified
electrician!
3. Never put the power cable near the fire or water
environment, to break or press the power cable is not
allowed.
4. It shall be stable and securely fixed in machine
installation procedure for the machine to be used
safely.
5. The working piece must be tightly fixed on table by
vise or clamp.
6. Use recommended cutting liquid; consult the
owner
’
s manual for recommendation.
7. Feed speed should be executed under safety scope,
please refer to manual 3-3.
8. Wear proper apparel, no loose clothing, gloves,
neckties, ring, and bracelet during operation. Always
wear safety glasses, cap and specific clothes.
9. Check all parts are in place and securely locked
before transportation. Bump and crash are
prohibited.
10. Regular maintenance and repaired should be
executed in accordance with the rules of manual.
11. Use the industrial suction to clean the chip is
recommended.
12. Use carrier to move the working piece which the
weight is more than 10 kg is recommended.
13. Wear safety gloves when install the drilling bit or
tooling to avoid hurting your hand is recommended.
14. This machine only be used following material brass,
cast iron, steel, iron, aluminum .
15. It is prohibited to open the pulley cover during
operation.
16. It is prohibited to use damaged or cracked parts
17. It is prohibited to remove the guard cover away
during operation.
18. It is prohibited to move the table when machine is
during operation.
19. It is prohibited to operate this machine beyond the
limit of its capacity.
20. Refer to this instruction for details.
21. It is prohibited to insert one's hand or finger into the
hole of working piece during operation.
22. It is prohibited all visitors and children should stand
near work area while the machine during operation.
23. It is prohibited to wear gloves, neckties, ring, bracelet
and loose clothing during operation.
24. It is prohibited to use plastic and wooden working.
25. Check again before switch on power,
A- Make sure the power voltage is for the machine.
B- Make sure the machine is completely assembled
and installed
C- Make sure chuck, working table, working piece
5
