Jet JTS-315LA, Operating Instructions Manual

Page: 95 / 141

Test Report No.: No.: 17706687 001
Part II of II
Page 55 of 63
EN 61029-2-1:2012
Clause Requirement

Test Result - Remark Verdict
saw blade at least down to the root of the teeth
and at least between the upper surface of the
workpiece and the riving knife,
c)Return to the initial position, in contact with the
top of the table, after the workpiece has moved
past the guard. N/A
18.1.101.Z1 The guard and its supporting system shall have
sufficient stability to reduce the risk of the saw
blade making contact with the guard P
For riving knife mounted saw blade guards:
The guard shall first be subjected to a load of 5N
at the front edge of the guard as defined in Figure
Z105a. The maximum deflection shall not be
more than 15 mm.
After test, the maximum
deflection of the guard is:
6.8mm P
For separately from riving knife mounted saw
blade guards:
The guard shall first be subjected to a load of 20N
at the front edge of the guard as defined in Figure
Z105b. The maximum allowable deflection shall
not be more than 8,0 mm.
Not applicable N/A
18.1.102 Guarding below the saw blade See below P
18.1.102.1 Access to dangerous moving parts under the table
shall not be possible at any depth of cut and any
angle of inclination of the saw blade
Compliance with 18 1 102 1 is checked by using
the test probe in Figure Z106
The test probe can not touch
dangerous moving parts
under the table at any depth
of cut and any angle of
inclination of the saw blade. P
18.1.103 Riving knife See below P
18.1.103.1 Circular saws shall be equipped with riving knife Riving knife provided. P
18.1.103.2 The riving knife shall be rigidly fixed and be in
alignment with the plane of the saw blade
(tolerance ±0.2mm) and disposed to it so as to
pass freely through the cutting groove. Checked and found
satisfactory. P
The position of the riving knife shall not change
relative to the saw blade when the depth of cut is
adjusted The position of the riving knife
does not change relative to
the saw blade when the depth
of cut is adjusted. P
18.1.103.3 The riving knife and its holder shall be so designed
as to allow the adjustment of the riving knife, for all
saw blade dia. resulting in cutting depths between
100% and 90% of the rate cutting depth, to comply Only one type saw blade and
the following condition is
observed. P