Jet JTS-315LA, Operating Instructions Manual

Page: 88 / 141

Test Report No.: No.: 17706687 001
Part II of II
Page 48 of 63
EN 61029-2-1:2012
Clause Requirement

Test Result - Remark Verdict
5 RATING P
6. CLASSIFICATION P
7 MARKING P
7.1 Addition: Circular saw benches shall be marked
with:
- maximum and minimum saw blade diameter;
- rated no-load speed;
- thickness of riving knife;
- maximum cutting capacity;
- indication of direction of rotation of the saw blade;
- saw blade bore diameter.
Provided on the label and on
the machine. P
If the upper guard is made of non-transparent
material, an indication of the cutting line in
alignment with the plane of the saw blade shall be
marked on the guard. Provided on the upper guard P
Circular saw benches for which different no-load
speeds can be selected shall be marked, close to
the means of adjustment, with details of the
method of changing the speed and the resultant
no-load speed. This may be done by means of
diagrams, etc.
Only on speed N/A
Where a machine is designed to operate at more
than one spindle speed, the following requirements
shall apply:
- on machines where a speed change is
achieved by changing the position of the drive
belts on the drive pulleys, the selected speed
shall be indicated on the same side of the
machine as the start control by a diagram
showing the relevant speed selected for each
combination of pulleys;
- on machines where a speed change is
achieved by an electronic control circuit, the
selected speed shall be indicated on the
machine at the selecting device (e.g. variable
speed control dial provided with numerical
speed settings).
Only on speed N/A