COMPONENT ACCESS
JennAir Built-in Coffee System
n
4-19
Removing the Transmission Assembly
1.
Complete the steps
from
“Removing the Back Panel and
Side Panel”
, prior to performing the following steps.
2.
Open service door to access Infuser assembly. Remove drip
tray from coffee system.
3.
Press in on the red clips on each side of the Infuser assembly
and then pull the infuser out of the coffee system.
4.
Remove the two screws securing the infuser sled. Remove
the screw holding the transmission kit fulcrum.
5.
From the back of the coffee system, remove the lower red
and black cables which are feeding DC power supply to the
transmission kit motor filter board.
6.
Remove the diverter/transmission assembly from coffee
system.
IMPORTANT:
While removing the transmission kit, be careful
not to damage the lower micro-switch cable, hall sensor
cable, and ground cables.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
