COMPONENT ACCESS
JennAir Built-in Coffee System
n
4-13
Grinder Setup
1.
Turn the white shaft clockwise till it tighten ups.
2.
Remove the upper part of the grinder by pulling it upwards.
3.
Verify the position of the white gasket with below figure.
4.
Turn the white shaft counterclockwise till it loosen. Pull up on
shaft to remove it.
5.
Grind settings are ready to change. To increase the
coarseness of the grind (thicker), turn the gear counter
clockwise*.
To decrease the coarseness of the grind (finer), turn the gear
clockwise*.
*
NOTE:
Before changing the setting, check and mark the
initial position of the metal ball you see through the holes on
the white ring. Change the setting carefully by turning the
white ring a maximum of one or two steps (one or two holes)
either way as required.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
