For Service Technician Use Only
DIAGNOSTICS & TROUBLESHOOTING
JennAir Built-in Coffee System
n
2-5
Customer Instruct and Technical Faults (Continued)
DISPLAYED MESSAGE
POSSIBLE CAUSE
SOLUTION
INSERT WATER SPOUT
The hot water spout is not inserted or is
inserted incorrectly.
Insert the water spout as far as it will go.
WATER CIRCUIT EMPTY PRESS OK TO START
FILLING PROCESS
The water circuit is empty.
Press
OK
and allow fresh water to drain
out of the spout; the flow will stop itself
automatically. If the problem persists,
make sure the water tank is fully inserted.
PRESS OK TO START CLEANING PROCESS
OR TURN MILK FROTH ADJUSTMENT KNOB
The milk container has been inserted with
the froth adjustment dial in the CLEAN
position.
To proceed with the CLEAN function, press
OK
or turn the froth adjustment dial to
one of the milk positions.
TURN THE MILK FROTH ADJUSTMENT
KNOB TO START CLEANING
Milk has been delivered recently and the
tube inside the milk container must be
cleaned.
Turn the froth adjustment dial to CLEAN.
TURN THE MILK FROTH ADJUSTMENT
KNOB TO MILK POSITION
The milk container has been inserted with
the froth adjustment dial in the CLEAN
position.
Turn the dial to the required froth
position.
INSERT WATER TANK
The water tank is not installed correctly.
Push the water tank back in until it clicks
into place.
Reminder that the appliance needs
descaling and/or the filter must be
replaced.
NOTE:
Water filter not available on this
model.
The descaling procedure needs to be
performed as soon as possible.
Reminder that the tubes inside the milk
container must be cleaned.
Turn the froth adjustment dial to CLEAN.
Reminder that the machine must be
descaled.
The descaling procedure needs to be
performed as soon as possible.
Indicated that the auto-start function is
enabled.
Disable the auto-start function from the
user SETTINGS menu.
Energy saving is enabled.
Disable the energy saving mode from the
user SETTINGS menu.
