79/116
SEWAGE
USE OF THE MARINE HEADS
Before you use the heads, check that the water intake valve and draining valve are open.
To empty the bowl:
- Set the control lever of the pump slantwise (FLUSH).
- Operate the pump.
To dry the bowl:
- Set the lever back vertical (DRY).
- Operate the pump.
In order to avoid clogging the heads, use absorbent paper exclusively.
Schedule a regular rinsing through of the heads with fresh water.
Close the valves after each use (in particular when the boat is unattended).
USE OF THE WASHBASINS AND SHOWERS
- Close the valves and turn off the taps after use.
- Operate the pump switch to drive the water out of the shower.
RESPECT OF THE ENVIRONMENT
- Remain informed of local regulations concerning the environment and follow the codes of
best practice.
- Do not drain the contents of the sewage tank near the coast or in zones where it is
forbidden.
- Make use of the port or marina pump facilities to drain the sewage tank before leaving port.
- Find out the international regulations against marine pollution (Marpol) and follow them as
far as possible.
RECOMMENDATION
When you are in a marina, use the club-house sanitary facilities (if there are).
Since it is prohibited to discharge the waste waters in some marinas or countries, you shall
use a waste holding tank (WHT).
RECOMMENDATION
- Completely empty the black water system before leaving the vessel unattended in
temperatures below freezing.
7
PLUMBING
Summary of Contents for SUN ODYSSEY 36I
