34
roller needs to be the same), and the locking screws on both sides of the plate
swing support are loosened. The fixed sleeves at both ends of the plate roller are
respectively loaded into the inner holes of the swing supports on both sides. The
adjustment of the plate roller is parallel to ink vibrating roller. The locking
screws on the swing supports are firmly tightened, and the tightening screws on the
eccentric sleeve are adjusted at both ends. Into the ring slot and tighten.
3.3.6、Installation of Water fountain roller 15
Fig.3.3.6 Installation of Water fountain roller 15
Installation Method: See Fig.3.3.6, Remove the bearing support cover on the inner
side of the operating side of the machine, install the two ends of the water
fountain roller in place (the side of the gear on the water fountain roller is the
operating side), and screw the driving side fastening screw. Reload the bearing
support cover of the operating side as mentioned above, tighten the fixed screw on
the cover, tighten the driving side fastening screw. (Note that the bearing cover
and support are paired parts that need to be used in combination with the serial
number).
Summary of Contents for JDL-420 Series
Page 1: ...1...
Page 16: ...16 Figure 3 1...
Page 55: ...55 3 4 Paper route of cold foil unwinding and rewinding...
