32
Installation Method: See fig.3.3.2, Loosen the locking bolts on the fixed support
seats on both sides, and load the adjusting eccentric sleeve on the shaft heads of
the rider roller into the fixed support seats on both sides respectively, then
adjust the rider roller parallel to ink vibrating roller, and tighten the locking
bolts on both sides of the fixed support seats., adjusting the eccentric sleeve with
the screw into the ring groove and tightening firmly at both ends
3.3.3、Installation of rider roller 5,6,7
Fig.3.3.3 Installation of Rider roller 5,6,7
Installation Method:See fig.3.3.3, Put the rider roller 7, 6, and 5 into the stop
positioning pin of the two sides baffle in sequence, adjust the fastening screws on
the two sides of the locking device, so that the above rider roller surfaces are
close to each other. Tighten the nut on the fastening screw to hold it firmly.
Summary of Contents for JDL-420 Series
Page 1: ...1...
Page 16: ...16 Figure 3 1...
Page 55: ...55 3 4 Paper route of cold foil unwinding and rewinding...
