JCM GEN5 Series, Operation And Maintenance Manual

Page: 36 / 70

P/N 960-100940R_Rev. A © 2016, JCM American Corporation
4 - 2
Section 4 GEN5™ Series Printer Disassembly/Reassembly
Print Mechanism Disassembly
The Print Mechanism includes the TOF Sensor and
Upper Presenter Motor. To disassemble it, proceed
as follows:
1. Carefully cut and remove tie wraps, as needed.
2. Remove the e-clip on the Hinge Pin (Figure 4-4
a ).
3. Pull the Hinge Pin (Figure 4-4 b ) out of the side
of the Print Head, separating the Mounting
Bracket from the Lid Assembly.
4. Remove four (4) screws securing the Print Head
(Figure 4-4 c
1
thru c
4
).
5. Remove the Print Head (Figure 4-4 d ) from the
Lid Assembly.
TOF Sensor Removal
To remove the TOF Sensor:
1. Remove the two (2) screws (Figure 4-5 a
1
& a
2
)
securing the right side cover (Figure 4-5 b ) to the
Print Mechanism. Then remove the right side
cover.
2. Move the Harness out of the Guides (Figure 4-6
a ).
3. Remove the Plastic Pin using a flat-edge screw-
driver (Figure 4-6 b ).
4. Carefully slide the TOF Sensor board out of the
Print Head (Figure 4-6 c ).
Figure 4-3
Remove Upper Presenter
a
1
a
2
b
Figure 4-4
Print Head Removal
a
b
c
1
c
2
c
3
c
4
d
Figure 4-5
Right Side Cover Removal
a
2
a
1
b
NOTE: Be sure to save the End Caps
that hold the TOF Sensor in place.
Figure 4-6
TOF Sensor Removal
a
b
c