JCG AC836 1200M DUAL BAND GIGABIT ROUTER
10
/
78
View from left to right:
USB 2.0 Port
10/100Mbps WAN Port
LAN Port (1,2,3,4)
Power Socket
Reset Button
Chapter 2 Connecting the router
2.1 Installation Environment Requirements
Operating Temperature: 0
℃
~40
℃
(32
℉
~104
℉
)
Operating Humidity: 10%~90%RH, Non-condensing
Keep the router far from any heater
Avoid direct irradiation of sunlight
Keep at least 2 inches (5 cm) of clear space around the router
2.2 Connecting the Router
There are 3 connection types to choose from: Static IP, DHCP, PPPoE. If you are unsure of
your connection method, please contact your Internet Service Provider. Please note that if
using the PPPOE option, you will have to enter a Username and Password (provided by
your Internet Service Provider) to gain access to the Internet.
JCG AC836 router supports easy setup which takes you less than 5 minutes, Netmask,
Gateway, Primary DNS or Secondary DNS are NOT required during the installation process.
Please follow the steps below to set up your router:
1.
Connect the modem to the WAN port on your router with an Ethernet cable.
2.
Turn on the modem.
3.
Turn on the router.
4.
Verify that the following LEDs are on and solid lit on your router.
Power, 2.4G, 5G
5.
Check the rear of your router and make sure the 2 indicators of WAN port are blinking.
