Varyscan 6 HMI 575
- 5 -
Unpacking of the Varyscan
®
equipment
First of all take out all parts of the carton.
??
Varyscan
®
6 575 HMI
??
These operating instructions
Check, if the delivery contains all parts.
If you notice a damage through transportation, please inform immediately your dealer. Also in case of noticing missing
parts.
Put in/exchange of the bulb
Warning:
Before open the projector pull out the mains plug!!!
Loosen the 8 screws at the lid of your Varyscan
®
6 575 HMI (head of the
spotlight) with a suitable screw-driver and lift the lid. You can see the bulb holder
in the back third of the head (see page 5) Now loosen the nuts no. 1 and no. 2
and remove the bulb from it’s holder. Put the new 575 HMI bulb into the holder
and tighten the nuts no. 1 and no. 2 manual. The point on the glass of the bulb
should on no account point to the concave mirror, respectively to the lenses
(outline page 4) it should point to the base sheet or to the lid. Take care that the bulb is tightened in the holder.
Warning:
Never touch the glass of bulb of the 575 HMI bulb itself!
An adjustment of the bulb is not necessary.
Starting the equipment
Hang up/put up of the Varyscan®
Your Varyscan
®
6 is suitable for mounting on a truss or in standing position as well.
2. Cabling of the Varyscan
®
Power supply:
A specialist should attach a plug to the open end of the connecting cable, or have the cable connected to 230 Volt / 50
Hertz.
DMX-cabling:
Connect the output of your DMX-controller with the first Varyscan
®
(controller DMX-Out; Varyscan
®
DMX-In) with the aid
of a 5 pole XLR-cable. Make sure that in DMX-out of the last Varyscan
®
there is a resistor (XLR-plug with a resistance of
120 Ohm between pin 2 and pin 3) plugged into.
3. Configuration of Varyscan
®
You have many functions at your disposal to adjust your Varyscan
®
optimal for your use. With a menu-system and the
four keys under the LCD-display you can adjust the functions.
Following the structure of the menu-system.
Summary of Contents for Varyscan 6 HMI 575
Page 2: ...Varyscan 6 HMI 575 2...
