Jayco PINNACLE, Manual

Page: 75 / 187

65
S
LIDEOUT
S
YSTEMS
1. Locate the slideout system controllers. There should be one for each slideout on the
recreation vehicle. They are typically located in the basement compartment in the
forward section of the recreation vehicle, either on the forward wall or on the ceiling.
In some models they may be behind a cargo lined panel.
2.
7KHFRQWUROOHUWKDWKDVPDOIXQFWLRQHGVKRXOGKDYHDÀDVKLQJUHG/('LQGLFDWLQJDKDOO
VLJQDOIDXOWZLOOÀDVKRUWLPHV
3. Press the “mode button” six times quickly, then press a seventh time and hold for
approximately 5 seconds.
4.
7KH UHG DQG JUHHQ /('¶V ZLOO EHJLQ WR ÀDVK LQGLFDWLQJ \RX DUH LQ RYHUULGH PRGH
Release the mode button.
5. Use either a wall switch, or one of the slide room switches located on the command
center panel (depending on the slideout). Press the switch toward the word IN or
RETRACT (printed next to the switch) and hold it until the unit comes in completely.
6. This will allow you to get the recreation vehicle to a service center to have the slideout
malfunction diagnosed.
During this override procedure the motors are not synchronized. Visually
ZDWFKWKHURRPDQGLIRQHVLGHLVPRYLQJVLJQL¿FDQWO\VORZHUWKDQWKHRWKHU
(or not at all), immediately stop and call your dealer or Customer Service.
%#76+10
If the system stalls our before reaching end of stroke OR if the room does not
close and seal tightly, call your dealer Customer Service.
%#76+10
Table of Contents Table of Contents Maintenance Record Maintenance Record