Jayco PINNACLE, Manual

Page: 162 / 187

152
E
LECTRONICS
Lower antenna before moving vehicle.
DONT’S
Don’t force elevating crank up or down.
Don’t rotate directional handle hard against stops.
Don’t travel with lift in up position.
Don’t leave lift part way up or down.
Don’t apply sealing compound or paint over top of base plate or anywhere on lift.
Lubricating the antenna
The elevating gear should be lubricated 3-4 times a year with silicone spray.
7ZRWLPHV\HDUO\RULQWKHHYHQWURWDWLQJWKHDQWHQQDEHFRPHVGLI¿FXOWQRUPDORSHUDWLRQ
can be restored by lubricating the bearing surface between the rotating gear housing and the
base plate. Any
silicone lubricant spray may be used.
Lubricate rubber quad ring on elevating shaft which is below worm gear with silicone spray
lubricant at least twice yearly. This will keep quad ring from becoming brittle which could
result in leaks down elevating shaft.
Refer to the manufacturer’s user guide for detailed information on lubricating the antenna.
T
ELEVISION
P
OWER
S
UPPLY
(I
F
S
O
E
QUIPPED
)
For good station reception, the TV power supply must be turned ON to view
local television stations. Turning the TV power supply ON sends 12-volt
DC through the cable to the TV roof antenna. The voltage energizes the
WUDQVLVWRUVLQWKHDQWHQQDKHDGDPSOL¿HU7KH79VLJQDOWKHQFRPHVGRZQ
the cable to the outlets.
Turn the TV power supply OFF to view cable television or to use a VCR or
DVD.
TV Power Supply
E
XTERIOR
S
LIDING
/ P
IVOTING
TV
Your recreation vehicle may be equipped with a TV located in an exterior compartment
that allows you to slide it in and out of the compartment, along with the ability to pivot and
reposition for viewing.
Extending the TV for viewing
1. Push down on the yellow tipped lever to release the sliding bracket.
2. Hold the yellow lever down (A) and pull the TV towards you out of the compartment.
Once you start sliding the TV out, release the lever and continue pulling the TV out
towards you. Make sure the cords do not get caught up in the mechanism as the TV
is pulled out.
3. With the silver brackets (on the back of the TV) extended, the TV is not completely out
of the compartment. Keep pulling on the TV until the top black slide bracket (B) is all
the way out to the end of the channel (C). The TV should clear the lined panel inside
the compartment when it is completely extended (D).
4. To pivot the TV into viewing position, pull up on the T-handle (E) which releases the
TV to pivot freely. Move the TV into the viewing position.