Jayco PINNACLE, Manual

Page: 121 / 187

111
P
LUMBING
S
YSTEM
If you smell propane gas then STOP! and follow the procedures listed in the
Fuel Systems section of this manual before attempting to operate the water
heater.
9#40+0)
Do not replace any component part with an accessory part that is not
authorized by the water heater manufacturer, such as an “add-on” electric
heating element. Such items are not approved to be installed and could create
an unsafe condition and will void all warranties.
9#40+0)
Operating instructions:
Read the safety and operating information provided in the manufacturer’s manual before
attempting to activate the water heater.
0DNHVXUHWKHZDWHUKHDWHULV¿OOHGZLWKZDWHUEHIRUHXVHHYHQPRPHQWDU\RSHUDWLRQRI
the water heater without water in it may result in damage to the tank heating element and/or
controls. Double check the bypass valves, make sure they are set properly.
Always
RSHQERWKWKHKRWDQGFROGZDWHUIDXFHWVZKHQ¿OOLQJWKHIUHVKZDWHUWDQNWRDOORZ
air pockets to be forced out of the water heater
Water heater switch (if so equipped)
The “propane GAS” water heater switch enables propane operation of the water heater. The
“ELECTRIC” water heater switch enables electric operation of the water heater. Switches
are typically located on the Monitor Panel. For detailed information on their operation refer
to the Monitor Panel section.
Water heater-pilot light (if so equipped)
This water heater is gas only with a pilot ignition. The water heater controls are typically
located in an outside compartment, and is ignited manually from the outside of the vehicle.
Hot water will be available in approximately 30 minutes.
Refer to the water heater manufacturer’s manual for detailed lighting instructions.
Water Heater pilot ignition
Table of Contents Table of Contents Maintenance Record Maintenance Record