Jayco PINNACLE, Manual

Page: 111 / 187

101
P
LUMBING
S
YSTEM
There are two different water systems in your recreation vehicle:
The fresh water system consists of the fresh water holding tank, fresh water connections,
water pump, outside shower assembly (if so equipped), water heater, faucets, tub/
VKRZHUDQGZDWHUSXUL¿FDWLRQV\VWHPLIVRHTXLSSHG
The waste water system consists of the waste water holding tank, sewage holding tank,
drains and toilet.
P
LUMBING
S
YSTEM
M
AINTENANCE
&KHFN DOO ¿WWLQJV SUHVVXUH DQG ZDVWH IRU OHDNV EHIRUH HDFK WULS RU EHIRUH YHKLFOH
storage as part of your normal maintenance:
,QVSHFW DOO IDXFHWV WKH ZDWHU SXUL¿FDWLRQ V\VWHP RSWLRQDO DQG VLQN FRQQHFWLRQV
LQFOXGLQJGUDLQEDVNHWVRU¿OWHUV
Inspect connections at the water pump and water heater.
At the end of every trip, you should drain any unused water from the fresh water system.
All water contains contaminant and mineral particles that can cause fresh water system
odors. Untreated well water is a major source of water system odors.
The fresh water (or potable water) system needs periodic sanitization and winterization
to take care of all the components within the plumbing system and help discourage the
growth of bacteria and other organisms that can contaminate the water supply.
7\SLFDOO\ WKHUH DUH ODEHOV DI¿[HG WR WKH H[WHULRU RI WKH UHFUHDWLRQ YHKLFOH VLGHZDOO WKDW
LQGLFDWHWKHORFDWLRQVRIWKHZDWHUV\VWHPGUDLQVDQG¿OOV%HDZDUHVRPHGUDLQYDOYHVPD\
EHORFDWHGLQVLGHWKHYHKLFOHRQFHWKHH[WHULRUODEHOLVIRXQGJRLQVLGHWR¿QGWKHGUDLQ
corresponding location).
M
ONITOR
P
ANEL
(I
F
S
O
E
QUIPPED
)
Depending on your model, the monitor panel may be located on an interior wall or on the
exterior utility center. The monitor panel allows you to monitor the fresh water, grey water,
black water and auxiliary battery levels. These functions are controlled using the “tact”
switches located on the monitor panel faceplate. The monitor panel operates on 12-volt DC
power supplied by either the converter or auxiliary battery. No power is drawn from the
battery unless a switch is pushed or turned ON. Fuses for the monitor panel are located in
the load center. Refer to the manufacturer’s operators manual for additional information.
Monitor Panel
Command Center Panel
(Monitor panel appearance and compnents listed may vary)
Table of Contents Table of Contents Maintenance Record Maintenance Record