Jason International, Inc. •
501.771.4477
Page 12 of 18
Customer Service : 800.255.5766
Copyright © 2014 Jason International.
Port
A strategically placed MicroSilk
®
port is provided for complete
enjoyment of your bath.
MicroSilk Unit
The MicroSilk
®
unit generates oxygen-rich microbubbles
that fill the bath. MicroSilk
®
units provided on Jason baths
are factory tested when assembled and again retested after
installation on the bath.
Blower
The blower generates warm air and pushes it through the air
jets. Blowers provided on Jason AirMasseur
®
baths are factory
tested when assembled and again retested after installation
on the bath.
Filling and Draining
Close the drain and fill the bath with water at least two (2)
inches (50mm) above the jets. The inlet temperature should
not exceed 40°C (104°F). When bath is in use, turn the unit
Off before draining the water. The bath unit and its plumbing
are designed to drain after each use whether used as a
hydrotherapy bath, soaking bath, or just taking a shower.
NOTE:
If the unit fails to operate, check the breaker panel to
ensure that the circuit breaker is on. Check the GFCI by testing
and resetting it. Also check the water level in the bath; it must
be above the MicroSilk
®
port for the pump to operate. If the
unit still fails to operate, refer to the Trouble Shooting Guide
section of this manual. If the unit still fails to operate and is
out of warranty, contact an authorized service technician for
repair. If the unit is within the warranty period, contact JASON
Technical Services at 800-255-5766.
DO NOT ATTEMPT TO
RESOLVE THE PROBLEM.
OPERATING INSTRUCTIONS, FEATURES, AND CONTROLS (cont.)