Jasic EVO 2.0 EM-200CT, Operator'S Manual

Page: 30 / 80

30
OPERATION MIG
MIG/MAG welding
Insert the welding torch (C) into the “ Euro connector for torch in MIG ”
output socket on the front panel of the machine and tighten it.
Insert the trailing cable plug (A) into the “+” output terminal of the welding machine
and tighten it clockwise.
Insert the work return lead cable plug (B) into the “ - ” output terminal
on the front panel of the welding machine and tighten it clockwise.
Install the welding wire on the spindle adapter.
Connect the cylinder equipped with a gas regulator to the
gas inlet on the back panel of the machine with a gas hose.
Correctly set the gas pressure and flow.
Ensure that the roller groove size on the fitted drive roll
matches the contact tip size of the
welding torch and the wire size being used.
Release the pressure arm of the wire feeder to thread the wire through
the guide tube and into the drive roll groove and then adjust the pressure arm, ensuring no sliding of
the wire. (too much pressure will lead to wire distortion which will affect wire feeding performance).
Pressing the wire inch button will activate the feed motor only and will start to feed the wire through the
torch until the wire comes through the contact tip.
You are now ready to start MIG welding.
MIG welding using gasless, self shielded MIG wire
Insert the welding torch (D) into the “ Euro connector for torch in MIG ” output
socket on the front panel of the machine and tighten it.
Insert the work return cable plug (E) into the “+” output terminal of the
welding machine and tighten it clockwise.
Insert the trailing cable plug (F) into the “ - ” output terminal on the
front panel of the welding machine and tighten it clockwise.
Install the wire spool on the spindle adapter ensuring that
the roller groove size on the drive roll fitted matches
the contact tip size of the welding torch and the wire
size being used.
Release the pressure arm of the wire feeder to thread
the wire through the guide tube and into the drive
roll groove.
Adjust the pressure arm ensuring no sliding of the wire. (Too much pressure will lead to wire distortion
which will affect wire feeding performance).
Pressing the wire inch button will activate the feed motor only and will start to feed the wire through
the torch until the wire comes through the contact tip.
You are now ready to start MIG welding.
A
B
E
F
C
D