Dimmer Operation
17
Revision 1.0 - 7-May-02
HUB24 Series Dimmer
Operating Manual
•
Select “6-2 Chase” on the menu.
•
Turn the encoder wheel to highlight the desired chase and press SELECT.
•
Turn the encoder wheel to highlight “Parameters” and press SELECT.
•
Turn the encoder wheel to highlight either “Level” or “Speed” or
“Crossfade” and press SELECT.
•
Turn the encoder wheel to change the value of the parameter. The effect of the
new value will be seen immediately if the chase is being played back .
•
Press OK to save the new parameter value, or press CANCEL to restore the
parameter to its original value.
4.2.28
Clear a Chase (6-2-#-3)
Menu
6 Record
6-2 Chase
6-2-# Chase #
6-2-#-3 Clear Chase
The entire contents of one chase can be cleared, ie. all the steps are deleted.
Note: It is not possible to remove an individual step from a chase.
•
Select “6-2 Chase” on the menu.
•
Turn the encoder wheel to highlight the chase to clear and press SELECT.
•
Turn the encoder wheel to highlight “Clear Chase” and press SELECT.
•
Press CONFIRM to clear the chase completely.
4.2.29
Playback a Snapshot (7-1)
Menu
7 Playback
7-1 Snapshot
When playing back a snapshot, it can be assigned control of all dimmer outputs or a
selection of dimmer outputs. Channels in the snapshot that have not been assigned an
output will be ignored.
•
Select “7-1 Snapshot” on the menu.
•
Turn the encoder wheel to highlight the snapshot to playback.
•
Press SELECT.
•
Turn the encoder wheel to highlight “All” or a single dimmer output.
•
Press SELECT.
•
If “All” was not selected, turn the encoder wheel and select other dimmer outputs
that need to be assigned to this playback.
Note: Each dimmer output can only controlled by one snapshot or chase at a time.
