page: 16 / 20
●
Fabric awning unroll till it drops to arms(for
motor drive must set end point position).
Fabric awning drops freely
●
Unscrew the Clamping screws „G” on all arms.
●
Set the slope at the cog "F " in any arms at the same slit "E".
●
Be sure that the cog "F" into the slot "E" well matched.
●
Fix all Clamping screws "G" tighten. During
the tightening subtend all elements (s. Figure).
Subtend selected
Hold in this position and fix
elements
Clamping screw "G”
●
Awning fabric tense, then check the front profile position (if necessary, change the final point position
according to the motor drive manual).
3.8.7. Awnings engine plug in to power (if Motor ordered)
CAUTION!
The electrical connection must be made by a licensed professionals. Electrical cables
connect as described in the attached schematic. The awning may be connected only if
the information on the rating plate agree with the power source.
When installing the motor cable make sure that no creases and sharp edges on the cable line. The
uninterrupted operation of the motor driven by electrical outlet is not allowed! The switch of the awnings
should be installed at a height of 125 cm and must be locked for off and on position, otherwise the end point
position is lost. The unroll and rollup limits are the factory setting. After changes to the settings, save them
according to description in manual.
●
End point position of the motor.
To make a change in the end point position, use the description of supplied motor.
When weared or damaged cables, do not use awning and repair by a licensed professionals.
