page: 11 / 20
The awning meets the wind class rating when the manufacturer's recommended number and type of the
mounting brackets were mounted with the correct mounting anchors. Before starting installation make sure
that the mounting surface is suitable for the mounting ‒ if were found the deviations of the surface strength,
then order more mounting brackets - (number of mounting brackets ,in standard, for Wall mounting Concrete
C20/25).
● Mark the brackets and drill the holes (position of the brackets in the following figure and description:
mounting
mounting
mounting
mounting
center of
roller tube
bracket
arm
bracket
bracket
bracket
the awning
support
Position A
bracket
Position B
Position C
Position D
width
roller tube
support bar
max 10 cm max 5 cm
± 5 cm
± 5 cm
2 brackets
- both brackets should be placed at a distance of not more than 10 cm from the outer edge of the
arm bracket (
position A
), symmetrically on both sides of the awning. If between the arm bracket and the
roller tube support there is not enough space, the brackets should be placed no more than 5 cm from the
inner edge of the arm bracket (
position B
), symmetrically on both sides of the awning.
3 brackets
‒ two brackets should be placed at a distance of not more than 10 cm from the outer edge of the
arm bracket (
position A
), symmetrically on both sides of the awning. If between the arm bracket and the
roller tube support there is not enough space, the brackets should be placed no more than 5 cm from the
inner edge of the arm bracket (
position B
), symmetrically on both sides of the awning. One of the brackets
should be placed in the middle of the width of the awning (
position D
) with a deviation of 5 cm or when a
holder of the roller tube (item 3.12 pos. 29) is in the middle next to it.
4 brackets
- two brackets should be placed at a distance of not more than 10 cm from the outer edge of the
arm bracket (
position A
), symmetrically on both sides of the awning. If between the arm bracket and the
roller tube support there is not enough space, the brackets should be placed no more than 5 cm from the
inner edge of the arm bracket (
position B
), symmetrically on both sides of the awning. The other two
brackets should be placed, symmetrically on both sides of the awning, between the arm bracket and center
of the awning width
(position C
).
5 brackets -
two brackets should be placed at a distance of not more than 10 cm from the outer edge of the
arm bracket
(position A),
symmetrically on both sides of the awning. If between the arm bracket and the
roller tube support there is not enough space, the brackets should be placed no more than 5 cm from the
inner edge of the arm bracket
(position B)
, symmetrically on both sides of the awning. The other two
brackets should be placed, symmetrically on both sides of the awning, between the arm bracket and center
of the awning width
(position C).
One of the brackets should be placed in the middle of the width of the
awning
(position D)
with a deviation of 5 cm or when a holder of the roller tube (item 3.12 pos. 29) is in the
middle next to it.
Another brackets -
should be symmetrically, taking into account the fact that the biggest load of support bar
are around arm brackets.
