Jacobsen PGM 19, Parts And Maintenance Manual

Page: 17 / 106

MAINTENANCE 4
GB-17
4.10 LUBRICATION ____________________________________________________________
The mower was designed for minimum lubrication. Over
greasing will produce high loads on the bearings and
engine; thereby reducing the performance of the
machine.
All maintenance intervals must be performed more
frequently when operating in extremely dusty conditions.
1. Always clean the grease fitting before and after lubri-
cating.
2. Apply grease with a manual grease gun and fill
slowly until grease begins to seep out. DO NOT use
compressed air guns.
3. For smooth operation of pivot points and other
friction points, apply several drops of SAE 30W oil.
Figure 4C
4.11 MAINTENANCE CHART_____________________________________________________
Recommended Inspection and Lubrication Intervals.
Daily 20 50 100 300 Yearly Lubricant
Air Cleaner.......................................I ........................................C
Combustion Chamber........................................................................................................... C
Engine Oil ........................................I .................. R ........................................R..........................................
...................... I
Fuel Line............................................................................................................................................... R - 2 yrs
Spark Plug .....................................................................................................A/R
Valve Clearance.................................................................................................................... A
Grease Locations (Figure 4C)
1 - Roller .......................................................... L.................................................................................... L
.................... II
2 - Height Adj. ........................................................................ L
............................................................................................ II
3 - RT Reel Shaft ............................................. L......................................................................................
..................... II
4 - Traction Roller ............................................. L......................................................................................
..................... II
5 - Clutch Shaft Bearing.......................................................................................................................... L
.................... II
6 - Clutch Pivot Shaft .............................................................................................................................. L
....................III
7 - Clutch Needle Bearing........................................................................................................................
................... III
★
8 - Traction Hub............................ ................... L......................................................................................
.....................III
9 - Wheel Bearings ............................................................................................................ .................... L
.................... II
10 - Reel Clutch Lever...................................... L......................................................................................
..................... II
11 - Chain Case ................................................................................................................. ....................R
....................IV
A - Add or Adjust C - Clean I - Inspect L- Lubricate R - Replace
Lubricants
I
- SAE 10W-30 Classified API SF or SG.
II
- Lithium Grease NLGI - Grade 2.
III
- Lubriplate® grease, Jacobsen Part No. 5001581
IV
- SAE EP-140 Oil - Drain and Refill
★
- Apply a light coat
1 2 1 2 3
4
5
6 7
8
9
10
11
9