Jackson AVENGER HT-E, Installation, Operation & Service Manual

Page: 17 / 61

11
OPERATING INSTRUCTIONS
INSTALLATION
To wash a rack, open the door completely and slide the rack into the unit. Close the
door, press the start button and the unit will start. After the machine has drained and
the cycle light turns off, the cycle is complete.
As the workday progresses, operators should regularly inspect the pan strainer to
ensure it has not become clogged. If the strainer becomes clogged, it will reduce the
washing capability of the machine. Instruct operators to clean out the pan strainer at
regular intervals or as required by work load.
At the end of the workday, open the door and remove the standpipe. Close the door
and push the power button. This will drain the tub completely and prevent the
machine from cycling. When the tub is empty, remove and clean the pan strainers
and set aside. Unscrew the wash and rinse arms from their manifolds, remove the
end caps and flush the arms with water. Use a brush to clean the inside of the arms.
If the nozzles appear to be clogged, use a toothpick to remove the obstruction.
Wipe the inside of the unit out, removing all soil and scraps. Reassemble the wash
and rinse arms and place them and the strainers in the unit. The arms should be
screwed on hand-tight; do not use tools to tighten them down.
In order to maintain the dishmachine at its optimum performance level, it is required
to remove lime and corrosion deposits on a frequent basis. A deliming solution will
be available from a detergent supplier. Read and follow all instructions on the label
of the deliming solution.
To proceed with the deliming operation, fill the dishmachine and add the correct amount
of deliming solution as recommended by the solution manufacturer. The water capacity of
the tank can be verified on the specification sheet(s) of this manual.
Perform the following operations to delime the dishmachine:
1. Verify standpipe is in place, turn the unit on and allow to complete a fill cycle.
2. Verify water level. If low, switch the unit off then immediately back on
(this will start a second fill cycle).
3. Open the door and verify water level is above standpipe. Add deliming
solution per the solution manufacturer’s recommendation.
4. Close the door and push the delime button on the front of the control panel.
5. Run the machine for the recommended period of time.
6. Press the delime button again and the pump will stop.
7. Open the door and remove the standpipe.
8. Press the power button to drain the machine and turn the unit off.
9. Wait five minutes, then inspect the inside of the machine. If the machine is
not delimed, run another time cycle as per the deliming solution’s instructions.
10. When clean, drain and refill the machine (steps 1 and 2).
11. Run delime mode for 10 minutes to remove residual deliming solution.
12. Drain and refill the machine.
WASHING A RACK
OF WARE
OPERATIONAL
INSPECTION
DELIMING
OPERATIONS
SHUTDOWN &
CLEANING
NOTE: If this machine is
equipped with an
HTS-11, scale prevention
and corrosion control
device, and lime is
becoming a frequent
problem, the cartridge
needs to be replaced.
To order a replacement
cartridge, call the
manufacturer to
have one shipped.