jablotron MAESTRO JA-65, Installation Manual

Page: 16 / 17

Alarm system JA-65 MAESTRO - 16 - MFM53003
16. Trouble shooting table
Problem possible cause solution
alarm after first powering the control panel is not in factory default setting perform a factory default reset
connected JA-60E keypad has no
function connecting cable does not connect the corresponding positions in the
keypad and in the control panel (1-1, 2-2, 3-3, 4-4) Check the colors of the cores in the cable
and positions on each side
impossible to enroll a wireless item
location of the item is not suitable and the radio signal level is too low
(too far away or an obstacle is in the way of communication) change location of the item, (fix it in the
new place temporary at first and then try it)
a fault is indicated on the keypad
and it is beeping check display for the reason of the trouble. Press key N to disable
beeping. The trouble information is stored in the event memory and it
can be reviewed entering F4 anytime in the future check the reason of the trouble in user
manual and fix it, or call the installer
If JA-65X is used, telephone line
failure is indicated and the phone
works as normal when you make a phone call longer than 15 minutes, it is interpreted
by the system that the tel. line is not ready. if this problem repeats, disable tel. line
checking in programming mode
PIR movement detector repeatedly
triggers alarms with no visible
reason check if there are: animals in the protected area (mice...), sudden
changes of temperature or intense air circulation, movement of
objects with temperature of about 37°C etc. increase detector’s immunity (internal
setting), change location of the detector or
use an optional sensor’s lens
fault or alarm C is indicated blown fuse in the control panel or radio communication jamming PC with Comlink SW gives details
system does not communicate
with connected PC the PC-60A cable is not connected to the correct COM connector on
the PC check the connection or select the port
number in SW manually
problem is not in this list call installer or the distributor for advice local hot line number:
17. Possibilities to extend the system
The JA-65 alarm system is a kit which can be tailor
configured according to the size of the house or the needs of
the user. It can combine wireless and wire operated
components.
17.1 Extension of the system with a subsystem
An additional JA-65 or JA-60 control panel can be enrolled as
a subsystem to the control panel (see 11.12.). Each system
then works as an independent system. However, any event in
the subsystem (alarm, tampering, failure or low battery) will
trigger the same kind of event on the main control panel (the
main control panel will display "J" as the event source). The
main control panel will not indicate the number of the item
which triggered the event, but this information is available on
the subsystem’s control panel.
Using this method, multiple level subsystems can be chained.
Warning: never enroll the top level control panel as a
subsystem of the lower level control panel. This would create
endless circle for the data and such an alarm system chain
would not work properly.
17.2 Extension of the system with a communicator
GSM communicator JA-60GSM
By using GSM communicator JA-60GSM you will get supervision
over the system wherever you are. Communicator sends SMS
messages, calls to predefined telephone numbers and plays
audible warning, communicates with 2 CMS, allows remote
access from a phone’s keypad and can be set and operate via
web page
www.GSMlink.cz .
Digital communicator JA-65X
Communicator JA-65X can communicate with a Monitoring
Station, send two voice messages, send five SMS messages
via SMS server (if it is supported in your country or dial a
numeric Pager). It can also communicate with a remote PC
(using ComLink SW and a JA-60U modem). By remotely
connected PC it is possible to set and/or operate the control
panel.
17.3 Brief overview of parts suitable for the JA-63
system
The brief overview you got along with this manual includes the
basic assortment of accessories. Jablotron is systematically
introducing new and improved items to the market. You can get
the most current information from your distributor or you can visit
Jablotron’s Internet home page at: www.jablotron.com