12
■
3.2 Fixture
Fig. 3-2 Fixture of the SY-956
(1) Pole faces of the measuring yoke
Place the measuring sample single sheet on these faces.
*
Do not touch
the pole faces
with your bare hands
. The measuring yoke may rust,
resulting in incorrect
measurements
.
*
Please
be careful with the edges
of the pole faces. Edges of the pole faces are not chamfered, in order to
suppress the generation of leakage flux.
Touching it may result in a cut on your hand
.
(2) Press block
Press the sample sheet from above. The press block is made of poly phenylene sulfide (PPS) resin.
*
PPS resin may deform at 160
C or higher.
(3) Slider
Move the press block up and down.
(4) Guide arms
Support long samples from the side. Guide arms are made of polyacetal resin (POM).
*
POM resin may deform at 80
C or higher.
(5) B coil holder
Supports the provided B Coils 01 and 02 from below.
(6) B coil jack
Insert the plug of the provided B Coils 01 and 02.
(7) S1 and S2 terminals
When using a B coil that did not originally come with the product, connect the beginning and ending of the
winding of the B coil to the S1 and S2 terminals.
(2) Press block
(3) Slider
(4) Guide arms
(5) B coil holder
(6) B coil jack
(7) S1 (black), S2 (red)
terminals
(1) Pole faces of the measuring yoke
Summary of Contents for SY-956
