V
Read the following safety information.
Read the next page.
Cautions
●
Turn off the main power switch on the front before connecting or disconnecting the power
cord.
Connecting or disconnecting the power cord while the power switch is ON (I side) may result in an
electric shock or failure.
●
Insert the power supply plug into the receptacle firmly.
If not, an electric shock, fire, or failure may occur.
●
When disconnecting the power cord from the receptacle, pull it out by grasping the plug.
Do not pull on the cord itself, as doing so may damage the cord and could result in an electric
shock or fire.
●
Before moving this product, confirm that external connection lines such as the power cord
and cables are removed.
The power cord and cable may be damaged causing a fire or electric shock.
●
Never replace the fuse inside the main unit. Contact Iwatsu office or our sales distributors for
replacement.
●
Use 3-core power cord in accordance with the power supply voltage.
If not, a fire may occur. In addition, if a 2-core power cord is used, a fire may occur.
Unless specified when purchasing this product, the power cord suitable for 100V system (center
voltage: 100V to 120V) is attached. If the power supply voltage is 200V system (center voltage:
200V to 240V), use 3-core power cord suitable for 200V system (optional) specified by Iwatsu
(rating voltage: 250V).
●
Do not apply an excessive voltage or current to the input connector.
If not, a fire, electric shock, damage to this product or a sample, or failure may occur.
The maximum allowable input voltage and current are as follows:
Input connector
Maximum allowable input voltage or current
Between S2-S1
200V
POWER INPUT
200V /
6A
●
Never touch the measuring yoke of this product with your bare hands.
The measuring yoke is made of FINEMET
®
. Touching the measuring yoke may cause it to rust,
resulting in incorrect measurements.
●
Do not measure a wet or dirty sample with this product.
The measuring yoke may rust or deteriorate, causing incorrect measurements.
●
Do not measure a sample with an uneven surface or with foreign objects on its surface.
Pole faces of the measuring yoke or the press block may get damaged.
Summary of Contents for SY-956
