20
Manual instruction
EN
humidity and dust.
Service according
•
to the table.
D r a i n
1.
the carburetor by
loosening the drain
screw. Drain the
fuel into a suitable
container.
WARNING: Fuel is extremely flammable
and is explosive under certain
conditions. Perform this task in a well
ventilated area with the engine stopped. Do not
smoke or allow flames or sparks in the area
during this procedure.
Change the engine oil (GN-1500; GN-3000; GN-6500)
2.
Remove the spark plug, and pour about a
3.
tablespoon of clean engine oil into the cylinder.
Crank the engine several revolutions to distribute
4.
the oil, then reinstall the spark plug.
Slowly pull the starter grip until resistance is felt.
5.
The piston is coming up on its compression
6.
stroke and both the intake and exhaust valves are
closed. Storing the engine in this position will help
to protect it from internal corrosion.
Installation of optional parts
Wheel kit installation
26. Axle
27. Wheel
28. Vibration mount
29. Support leg
a. Flat washer
b. Retain pin
c. 30mm cap screws
d. 20mm cap screws
e. Nut
Slide axle (26) through both axle mounting
1.
brackets on cradle frame;
Slide a wheel (27) over the axle;
2.
Retain wheel on axle with the flat washer and
3.
retain pin;
Repeat step 2. and 3. to secure second wheel;
4.
Secure each vibration mount (28) to the support
5.
leg (29) with two 30mm cap screws and nuts;
Secure the support leg (29) with two 20mm cap
6.
screws and nuts;
fig.14
e
d
21
28
c
b
26
a
27
Battery Tray Kit installation
30. Battery guard
31. Battery tray
32. Starter cable
33. Starter solenoid
34. Ground cable
35. Battery bracket
36. Battery guard plate
Install the battery guard (30) on the frame. Set
1.
the battery tray (31) on the battery guard (30) and
tighten the bolts.
Route the starter cable (32) under the tank and
2.
connect it to the starter solenoid (33).
Connect the ground cable (34) to the generator
3.
rear housing.
Set the battery on the battery tray (31) and
4.
secure with the battery bracket (35). Connect
the starter cable (32) to the battery po)
terminal first, then to the negative(-) terminal. When
disconnecting, disconnect at the battery negative(-)
terminal first.
Install the battery guard plate (36) on the battery
5.
guard (30).
fig.13
