34
Replace coolant
Only proceed with the engine stopped and at a low temperature, so as
to avoid the risk of burning.
Provide suitable containers to ensure that no coolant is dispersed
into the environment.
Remove the plugs on the circuit components and wait until the
circuit has drained completely (the location of plugs is given in the
section ENGINE TECHNICAL DATA). After emptying, replace the
plugs in their housings, making sure that the seal rings are all
undamaged.
Fill up the circuit as indicated in the table REFUELLING.
Bleed the circuit and top-up if necessary.
Change oil vapour filter
(figure on page 30)
Only proceed with the engine stopped and at a low temperature, so as
to avoid the risk of burning.
Unfasten the screws and remove the cover (5) to the filter
compartment.
Remove the two filters, and dispose of them according to current
requirements.
Insert the new filters and replace the cover.
Drain/suck condensation from fuel tank/s
Inspect sea chest
Check sea water pump rotor
Clean heat exchangers
Clean the turbocharger
Adjust play in valves-rocker arms
The method used to change the oil in the marine gear is indicated in the
relevant documentation supplied by the Manufacturer of the marine
gear itself.
WARNING
The operations listed below must only be carried out by qualified
staff from the IVECO MOTORS Service Centres or by staff from the
Boatbuilders.
The methods used to perform them are described in the Technical
and Repair Manuals.
