28
REQUIREMENTS
1. Do not disconnect the batteries with the engine running.
2. Do not carry out arc welding operations in the vicinity of the engine
without first removing electrical cables and electronic units.
3. After each maintenance operation involving disconnection of the
battery/batteries, make sure that the terminals have been properly
locked onto the poles.
4. Do not use battery chargers to start the engine.
5. Disconnect the on-board network battery/batteries when
recharging.
6. Do not paint the appliances, components and electrical connectors
equipping the engine.
7. Disconnect the battery/batteries before any electrical operations.
8. Contact the Boatyard before installing electronic equipment on
board (two-way radios, echo-sounding equipment, etc.).
HOW TO PROCEED
Check oil level in engine
Only proceed with the engine stopped and at a low temperature, so as
to avoid the risk of burning.
Using the dipstick (1), check that the oil level is between the "Min"
and "Max" levels.
If the level is too low, top up through the inlet on the cylinder head,
after first removing the relevant cap (2).
WARNING
After topping up, make sure that the oil level does not exceed the
"Max" limit marked on the dipstick.
Make sure that the dipstick is inserted properly and the filler
cap is turned in a clockwise direction until it stops turning
completely.
3
2
1
04_007_N
