18
Stopping the engine
Before stopping the engine it is recommended you run it for a few
minutes at minimum speed with no load; this will allow the temperature
to drop evenly and will avoid harmful thermal shocks.
A.
From the main IVECO MOTORS control panel:
turn the
key switch to the rest position
8A
.
B.
From the secondary IVECO MOTORS control panel:
press the red STOP button (8).
To re-start the engine from the main control panel:
1. Return the key switch to the rest position
8A
to reset all the on-
board control panel functions.
2. Proceed as indicated in the relevant paragraph.
To re-start the engine from the secondary control panel:
1. Make sure that the panel has been enabled (key switch on the main
control panel turned to position
8B
).
2. START button (11) and release it when the engine has started,
making sure that the instruments with analogue displays are
showing plausible values.
RECOGNISING ALARMS
The following shows the meaning of the symbols associated with each
of the indicator lights on the main and secondary control panels some
types of engine and relevant equipment only make some of the above
mentioned functions available. If the Boatyard uses different technical
options there may also be changes to the above.
* Alarm functions not available with standard setup
04_359_N
* Oil vapour filter
blocked
Alternator
malfunction
Oil pressure low
Coolant
temperature high
Over-revs
* Coolant level low
EDC engine control
system malfunction
* Air filter
blocked
Maintenance
interval expired
* Oil filter
blocked
* Pre-lubrication
in progress
* Pre-post
heating
* Fuel filter
blocked
Water in the
fuel filter
