Page 23 (52)
Ver 2_en_2022-06-27
Assembly Instructions
Envistar Flex
6.1
Assembly, step by step
Unit parts in sectioned configuration are also assembledaccording to the
instructions in the section ASSEMBLY, SECTIONED CONFIGURATION.
1. Take the set-up drawing that comes with the unit or download from
IV Produkt’s order portal
(Technical Data). See
"1.1 Intended use”, page 6.
2. Take out suitable tools. See
"2.3 Tools for assembly”, page 10.
3. Assemble and adjust the support. See
"6.2 Assemble fan room support (EMMT-05)”, page
23.
4. Fit together unit parts in sectioned configuration. See
"7 ASSEMBLY, SECTIONED CONFI-
GURATION”, page 30.
5. Push the first unit part onto the stand.
6. Fit the sealing strip. See
"6.3 Fit sealing strip”, page 24
.
7. Push on the next unit part and slide them together on the support.
8. Join the unit parts together. See
"6.4 Join the parts together”, page 25.
9. Repeat steps 4—7 until everything is in place and is correctly assembled.
10. Connect the unit parts together with quick connectors and assemble other control equip-
ment. See
"6.5 Quick connectors”, page 27
.
11. Assemble drainage and water trap. See
"11 CONNECT DRAINAGE, WATER TRAP”, page
49
.
12. Fit cover detail. See
"6.7 Fit cover detail on join”, page 29
.
13. Ensure everything is properly assembled. See
"13 AFTER ASSEMBLY”, page 51
and if
problems arise
"14 SUPPORT”, page 51
.
6.2
Assemble fan room support (EMMT-05)
• The unit should tilt slightly forward (towards the inspection side) for
condensation runoff and drainage. The inclination may be a maximum of
3 mm/m.
• Longitudinal beams must be level and the top of the support structure
must be level.
• The support must not, at any point, be bent down more than 2 mm. If
the distance between the transverse beams of the support is >1700
mm (c/c), additional cross beams are mounted to prevent bending
downwards.
00049
2
1
Figure: Support
1. Distance between transverse beams (c/c)
2. Longitudinal beam level
A general support drawing is included in the delivery of the support. The order-specific
