Page 15 (52)
Ver 2_en_2022-06-27
Assembly Instructions
Envistar Flex
4.4
Lift with bracket EMMT-08, for 50 profile
00180
Follow the instructions for lifting in this manual.
Never exceed the specified weight for the respective lifting method or
lifting equipment.
Slide stops must be fitted when lifting, if bracket is used.
Replace used T-bolts and nuts with new ones after each lift.
•
•
•
•
A falling unit when lifting can cause crushing injuries.
Risk of serious crushing injury.
WARNING!
• The bracket does not fit the 60 profile.
• Load per lifting bracket ≤ 400 kg.
• Load if all four brackets are used ≤ 1600 kg.
• A safety factor of 1.6 has been utilised in static testing of the lifting
bracket.
• Use shackle with safety factor 6:1.
• Brackets must not be mounted downwards or sideways.
• Lifting brackets must not be mounted in the middle profile of double
stacked parts.
00097
1
5
3
2
4
6
Figure: Lifting bracket EMMT-08
1. Lifting bracket EMMT-08
2. Lifting lug
3. Lift stop sticker
4. Wing nut
5. Slide stop sticker
6. Slide stop
EMMT-08 is delivered in a set of four.
1. Place the lifting brackets in the bottom four corners of the unit or unit part (on the longest
sides of the part), with the lifting lug upwards.
2. Push the brackets into the horizontal track in the unit’s aluminium profile.
3. Push the slide stop into the vertical track in the unit’s aluminium profile.
4. Lock by tightening the wing nut.
