Operation Manual – ITW GSE 6400 Tier 4
11:27:47
Setup Menu
28/06/2013
Modbus Slave Address
LED Brightness
Unit of Measure
Diagnostic Mode
Menu Lock Bypass
Battery Replaced
◄
Back
●
Select Parameter.
Setup (continued) – Menu structure
Highlight the by using the
navigation
◄▼▲►
keys.
Press
●
to select ”Setup” sub-menu.
Use the the
▼
/
▲
to browse through the
various set-up lines / parameters. The
selectable line will be highlighed in
green.
Press
●
to select the parameter you
want to change.
Press
●
to Modify the parameter.
Parameter will now be highlighted in
green.
Use the the
▼
/
▲
to adjust parameter.
Press
●
to save changes.
Use
◄
to leave the sub-menu and
return to The basic Icon Menu.
Notice!
Availability of parameters may vary
depending on the mode of the unit
Standby / Engine Running etc.
Settings:
Low
Medium
High
Refer to Section 3 – 4.14
11:27:47
Setup Menu
28/06/2013
LED Brightness
Low
◄
Back
●
Modify
Settings:
1 – 247
Refer to Section 3 – 4.13
Settings:
Metric
Imperial
Refer to Section 3 – 4.15
11:27:47
Setup Menu
28/06/2013
Unit of Measure
Imperial
◄
Back
●
Modify
11:27:47
Setup Menu
28/06/2013
Modbus Slave Address
1
◄
Back
●
Modify
Settings:
Disabled
Enabled
Refer to Section 3 – 4.17
11:27:47
Setup Menu
28/06/2013
Menu Lock Bypass
Disabled
◄
Back
●
Modify
11:27:47
Setup Menu
28/06/2013
Diagnostic Mode
Disabled
◄
Back
●
Modify
Settings:
Disabled
Engine Only
AVR Battery Only
Engine Interface
Refer to Section 3 – 4.16
Settings:
Yes
No
Refer to Section 3 – 4.18
11:27:47
Setup Menu
28/06/2013
Warning: Do not confirm unless the
Control Board battery has been
replaced.
Confirm Battery Replaced
No
◄
Back
●
Modify
OM2248 Rev B
Page 41 of 104
