ITV spika, User Manual

Page: 10 / 60

8
USER MANUAL SPIKA
Start-Up
(1) Previous Checkup
a) Is the machine leveled?
b) Voltage and frequency are the same as those on the nameplate?
c) Are the discharges connected and operating?
d) Will the ambient temperature and water temperature remain in the following range?
e) Is water pressure appropriate?
NOTE: In case input water pressure is higher than 85 psi (6 bar), install a pressure regulator.
For undercounter machines:
In case the room temperature exceeds 85ºF (29.5ºC) or water inlet temperature exceeds 68ºF (20ºC) the following
adjustments should be made to ensure a proper efficiency.
MINIMUM 14 psig (1 Bar)
MAXIMUM 85 psig (6 Bar)
ROOM WATER
MAXIMUM
109º F / 43º C 95º F / 35ºC
MINIMUM
41º F / 5º C 41º F / 5ºC
(2) Start-Up
Once the installation instructions are followed (ventilation, site conditions, temperatures, water quality, etc.), proceed
as follows:
1) Open the water inlet. Verify the no existence of leakages.
2) For undercounter models open the door and remove the protection elements on the shield. For modular models
remove the two locking screws on top of machine, take off the front panel and remove protection elements on the
shield and also on the thickness sensor.
3) Verify that the shield moves freely. For modular models verify also the thickness sensor moves freely.
4) Connect the machine to the power supply.
5) For undercounter models: push the blue switch on the machine front side. For modular models: push the blue
switch found on the back of the machine and then set the ice-wash switch to the position I.
6) Verify that there are no vibrations or frictions on the elements.
7) Verify that the water fall to the evaporator is occurring uniformly and all ice cubes are properly watered.
The wheel G1 should have 2
more pins than G2, one by each
side of those from the other.
The frist pin in G2 and G3
wheels must coincide in their
position.
Air temp >85ºF
Water temp >68ºF
Air temp <85ºF
Water temp <68ºF
G1 G2 G3 G1 G2 G3
SPIKA NG 125 6 4 2 12 10 5
FIBER
SPIKA NG 175 9 7 3 12 10 5
SPIKA NG 215 9 7 3 12 10 5
SPIKA NG 285 9 7 3 12 10 5
SPIKA 125 V2 6 4 2 8 6 5
CDC
SPIKA 175 11 9 5 14 12 8
SPIKA 215 11 9 5 14 12 9
SPIKA 285 11 9 5 14 12 10
G1
G2
G3
Indicating the number of white pins