ITT Goulds Pumps V 3298, Installation, Operation And Maintenance Instructions

Page: 55 / 148

17. Tighten jacking screws evenly and in sequence until
the magnet assembly (740B) can be removed.
18. Remove magnet assembly (740B) and set aside away
from attracting metals (Fig. 69).
19. Remove
5
16
" rub ring cap screw (372Y) from bottom
of bearing frame (228). (Fig. 70)
20. Remove rub ring (144A) from bearing frame
(228) (Fig. 70).
21. Remove bearing end cover bolts (370C) (Fig. 71).
22. Install two end cover bolts (370C) in jacking screw
holes, tighten evenly to remove bearing end cover
(109A).
23. Slide bearing end cover (109A) back. Labyrinth oil
seal (332A) will slide back with the end cover.
24. Remove labyrinth seal (332A) (Fig. 71).
25. Remove bearing end cover (109A). Remove gasket
(360A) and discard (Fig. 71).
26. Remove drive shaft (122B) with ball bearings (112)
and wave washer (529) (Fig. 72).
27. Press bearings (112) off shaft and inspect.
28. Remove lip seal (333D) as shown (Fig. 73).
This completes disassembly of the 3298
M frame mounted version.
3298 Family Rev. 4/07
55
Fig. 69
6
Fig. 70
Fig. 71
Fig. 72
Fig. 73