7.3.1 Clean
CAUTION!
Danger of injury due to sharp edges!
–
Only lift the cover hood on the grips.
–
Do not touch the edges of the cover hood.
NOTICE!
Material damage due to incorrect cleaning!
–
Only disassemble the pump casing for cleaning purposes.
–
Have other work completed by the manufacturer only.
–
Do not spray directly into the pump and onto feed screws with
the high-pressure cleaner.
–
Only use approved food-safe cleaners.
–
When carrying out pressure tests or rinsing do not expose
pumps, hoses or fittings to impermissible pressure.
1.
Cleaning is completed with a suitable cleaner, e.g. warm water of approx.
40 °C with an industry-standard dishwasher cleaner.
2.
To permanently remove bacteria, germs, and cleaning residue, rinse the
cleaned parts thoroughly with hot water of approx. 80 °C.
7.3.2 Maintenance table
Unless otherwise necessary due to the operating mode, carry out mainte-
nance work in accordance with the following table.
Maintenance – intervals and measures to be carried out
Interval
Module (if available)
Who
Measure
Once, after reaching
operating temperature
for the first time
Pump, clutch, motor
Specialist per-
sonnel
Check hot alignment (
into account peak height changes’ on page 35
).
Hourly, during start-up
phase
Barrier system
1)
Specialist per-
sonnel
n
Check filter and bleed valve for soiling.
1)
n
Check filling level of barrier fluid.
1)
Weekly
Coupling
Specialist per-
sonnel
n
Check the coupling for wear.
Gear casing
2)
Specialist per-
sonnel
n
Check oil level.
n
).
Fig. 18: Grips on cover hood
Maintenance and repairs
61
Type SLH-4U
0
3
/20
20
JP Rev. 1
