18
c)
take the cable (not connected to the power supply!) and connect the three phase conductors
with the terminal board of the main switch on the upper part. Fix the three conductors by tighte-
ning the worm screws. When carrying out this operation, make sure that the bare part of the wire
is completely inserted in the clamp, to prevent contact with the outside
d) connect the conductor with green and yellow casing to the main earth terminal board of the
machine (marked with "PE") situated within the cabinet;
e) block the cable by tightening the cable press;
f) close the door of the electrical cabinet by means of the two locks, using the key, and set the
main switch "IG" to position "1".
THE KEY MUST BE REMOVED FROM THE ELECTRICAL CABINET AND
ENTRUSTED TO A RESPONSIBLE.
Summary of Contents for 183630114
