29
INSTALLER
Electrodes
To remove and restore the ignition electrode (1) or
detector electrode (2):
- detach the electrode high voltage and ionisation
cables from the flame control board, undo the screws
and extract the electrode assembly;
- fit new ones in reverse order and replace the gaskets
(3); the electrodes will only fit in one way;
- take care not to damage the electrodes' ceramic
insulation and reconnect the cables to the board as
before;
Convection fan
Remove and restore the fan as follows:
- remove the electrical connections on the fan motor;
- remove the earth connection on the motor;
- undo the four screws securing the fan mounts to the
heater's back frame and extract it;
- install a new unit in reverse order: first install the
mounts, including dampers, to the slots, then secure it
to the frame and restore the electrical connections to
prevent malfunctions (such as incorrect speeds or short
circuits).
White-Rodgers gas valve windings
Remove and restore the windings as follows:
- undo the two screws securing the bracket locking the
windings (1) to the valve (2) and remove it;
- extract the faulty winding with care;
- fit the new winding and connect its plug (3) to the
socket;
4 - Restore the bracket (4) to secure the windings.
Trigas modulator windings
Remove and restore the winding as follows:
- undo the electrical connections
- undo the nut (1) securing the winding (2) to the valve
(3) and remove it;
- extract the faulty winding with care;
- fit the new winding in the right position;
- restore the electrical connections.
se
se
se
se
Summary of Contents for Eco SC Series
Page 1: ...SC SV SE Wall gas stoves NATURAL...
Page 37: ...37 notes notes...
Page 38: ...38 notes...
Page 39: ...39 warranty...
