STARGEL
Stargel - 2018/04 - rev. 03
- 26 -
EN
5.8.2 Hopper cover disassembly
To clean the mix filling area, withdraw the cover fixing rod (pos. 6) and remove it.
The cover is provided with a small panel to prevent ice cream from going back to the hopper,
which must be disassembled to be cleaned.
Wash all disassembled parts with water and cleaning/sanitizing solution, then rinse.
5.9 SANITIZATION
This operation is required after each production cycle.
With the machine off, the beater unit inserted and the front lid closed, add cleaning/sanitizing
solution, prepared in water at 45-60°C, to the freezing barrel.
Select "CLEANOUT" function. Let the machine run 10/15 seconds.
WARNING
Too long running at "CLEANOUT" position with empty barrel or with water and cleans
-
ing solutions will wear out beater very quickly.
Let the cleaning/sanitizing solution act into the cylinder about 10/15 minutes.
Fully draining the sanitizing solution from the freezing cylinder.
ATTENTION
Do not touch sanitized parts with hands, napkins, or else.
WARNING
Before starting again with ice cream production, rinse thoroughly with just water, in
order to remove any residue of sanitizing solution.
5.10 HYGIENE
Ice cream fat contents are ideal fields for proliferation of mildew and bacteria.
To eliminate them, parts in contact with mix and ice cream must be thoroughly washed and cleaned.
Stainless steel materials as well as plastic and rubber ones used for the construction of these parts
and their particular design make cleaning easy, but cannot prevent the growth of mildew and
bacteria if not properly cleaned.
1
289
960
363
7A
338
726
502
1126 304
501
290
350
362
291A
5.8.1 Ice cream door disassembly (standard front lid)
•
Lift the lid by turning the lever (ref. 1) by 90° towards the left.
•
Lift the lever and the door and lock the lid upwards by turning the lever rightwards till its stop.
•
Remove the OR from the lid sliding rod, now, and take it out, in order to release the lever, as
well.
•
Remove the OR of the lid itself.
•
Wash all disassembled parts with water and cleaning/sanitizing solution, then rinse.
•
Reassemble all parts previously disassembled, minding to grease the OR with a film of edible
fat.
