Isuzu NOVOCITI, User Manual

Page: 84 / 89

80
If The Brakes Don’t Work
If the brakes unexpectedly becomes ineffective; reduce the speed by changing gears quickly
from first gear, to the second and the third. Tightly hold the steering wheel, while gradually pull
the handbrake lever. Pull the vehicle stop on the side of the road.
In cases of Running Out of Accumulation
Use jumper cables and connect to anothe
r vehicle’s accumulator to run the engine in this
condition.
1. Check the accumulator liquid in the disabled vehicle.
2. Use a vehicle that has a charged accumulator in the same voltage.
3. Open the Accumulator cabinet. Connect the jumper cables.
4. After connecting the cables, start the engine of the vehicle with the auxiliary battery.
5. In a slow manner, raise the RPM of the engine of the vehicle with the auxiliary accumulator
of the disabled vehicle and start the engine.
6. The disabled vehicle's engine works by applying the reverse procedure is followed in the
process of reinforcing and connecting cables.

The positive and negative terminals of the battery contact with each other
definitely should be avoided.

When connecting cables, the binding rings should not be allowed to touch
each other.

To charge the accumulator please contact to the closest Isuzu service.

When the engine is running, remove one of the terminals of the
accumulator. It may cause a malfunction in the electrical system.
If The Engine Overheats
If the engine is overheated engine power drops and engine
cooling temperature gauge point above the upper limit of the
safety area and enters the “H” area. Engine overheating
warning light illuminates and you can hear an audible alert.
In this case, perform the following corrective actions.
1. Turn on the hazard warning flashers and park the car in a safe place that does not prevent
traffic from operating, immediately.
2. Keep the temperature of the engine by running the engine at idle for a while for it to
decrease.
3. Engine coolant temperature indicator shows when the point of the safety returns to the
middle of the area, stop the engine.
4. After the motor has sufficiently cooled, check the coolant level in the radiator and the
hydraulic oil in the container. If level is insufficient, add coolant. Also, check whether the fan
belt is loose or damaged.