Isuzu NOVOCITI, User Manual

Page: 71 / 89

67
To pull the air out of the system, follow these steps:
1. In order to remove the remaining air from the system oil by increasing the temperature; turn
the steering wheel in both directions several times until the end. Raise oil temperature from
60 to 80°C. When it rises, stop the engine and wait approximately 5 minutes for the high
temperature of the air dissociates from the oil collection.
2. Check the oil level in the hydraulic oil container and also against leakage at the joints.
3. When you turn the steering wheel in a comfortable way, and in order to check if there
are any abnormal sounds when turning the steering wheel, do a test drive on the road.
HUB UNIT GREASE OIL
To replace the grease front and rear bearing disassembly
and re-assembly processing is required since these
operations must be made in the your Isuzu service.
CHASSIS COMPONENTS LUBRICATION WITH GREASE
The type of grease used in the specified chassis components (properties) is different from the
type specified to be used in another components. For each component, use only the specified
grease and lubrication according to maintenance schedule.
Grease universal joints of each drive shaft, 4 needle bearing oil seal should be lubricated
excessively. After oiling with grease, wipe the leftover grease.
WINDSHIELD WASHER WATER
Check the level of windshield washer water in the tank.
Filling Up Windshield Washer Water
1. windscreen washer water tank is located on the left side of the front side of the vehicle
accumulator cupboard.
2. Open the lid and the tank to the brim and fill it up with windshield washer water.