
20
Stopping the Engine
Pull the handbrake fully. With the gas pedal released, turn the ignition key to “ACC” or
“LOCK” (LOCKING) mode.
OPENING and CLOSING the DOORS
Chip Immobilizer transponder Key
The key contains an immobilizer transponder chip. The immobilizer anti-theft system ensures
that the engine will only start when it receives signals from the previously recorded
transponder.
However, you may not be able to start the engine in the situations listed below, even if a pre-
registered key is used. If the engine does not start because of the metal key chain, remove the
key chain and try again and set the ignition key on “ACC” mode or “LOCK” (LOCKING) mode
and
then turn it to “START” (START) mode.
Do not leave the ignition key on “START” more than 10 seconds.
Keep the metal label with key code on away from the vehicle.
If you lose the key, contact to the nearest Isuzu Service.
Keyless Entry System
With the keyless entry system you can open the doors/or lock them simply by pressing the
remote control button.
Opening
Press the door release button on the remote control. The car’s keyless entry system causes
the right and left turn signal lights to illuminate twice at the same time after receiving signals
from the remote control unit.
Locking
Press the locking option on the remote control. The vehicle’s keyless entry system causes the
right-hand side turn signal lamps to illuminate once after receiving signals from the remote
control unit.
Summary of Contents for NOVOCITI
