9 mm
30 mm
90 mm
1 2 3 4 5
5
1 4 3 2 5
5
1
2
3
25 mm
12.5 mm
2.5 mm
1
DIN L
DIN R
5.6 Mounting the slide channel
1.
Insert the lever pin (12.5 or 25 mm) into the sliding
piece and fasten it with the retaining washer.
The short pin is used for doors without rabbet.
2.
Place the individual parts into the slide channel as
shown in the illustration and fasten the mounting part.
1 Slide
channel
2 Latching
action
3 Buffer
4 Sliding
piece
5 Mounting
piece
3.
Screw the slide channel with 2 screws into the
prepared holes.
For the fastening, use dowels and screws that match
the background.
4.
Insert the casing onto the slide channel.
5.
Insert the end caps onto the spacers.
6.
Insert the spacers with the end caps into the casing.
|
Ensure the correct mounting position; the spacers and
end caps must be installed as shown in figure 4.
7.
Align everything so that the end caps are flush with the
casing on both sides.
5.5 Driving the axis extension into the lever
1.
Drive the axis extension into the lever.
Mounting position on the hinge side in case of an
installation with slide channel and on the opposite
hinge side in case of a normal arm assembly.
Mounting position on the opposite hinge side in case of
an installation with slide channel, the square must be
turned by 45°.
1.
2.
4
IS 9100
—
15
ISEO
