36
When the lamp turns off, stop the engine
and correct the trouble (clogged grass or
dust around engine, radiator, etc.). Then
re-start operation.
WARNING:When inspecting the radiator, be
sure that the engine cools down sufficiently.
Never release the radiator cap while the
coolant is hot, or boiling water will gush out.
1.4. PTO SWITCH
With this switch the PTO can be either engaged to spin or
disengaged to stop.
M
:
Turn the switch to the position indicated by this
mark, and the PTO shaft starts spinning. Pull the
switch and turn it clockwise to engage.
N
:
Turn the switch to the position indicated by this
mark, and the PTO shaft stops spinning. Turn the
switch counter clockwise to disengage.
1.5. HOURMETER
The hourmeter counts operation hours of the Zero turn
mower and shows them.
The lower figure indicates a tenth of an hour of operation.
1.6. LIFT LEVER
With this lever the lift link is raised or lowered.
d
:
in this position, the lift link is lowered.
u
:
in this position, the lift link is raised.
CAUTION: When servicing or leaving the
Zero turn mower, be sure to lower the mower
deck to the ground.
1.7. FUEL GAUGE
The gauge indicates the fuel level.
1.8 CUTTING HEIGHT ADJUST DIAL
Use the dial to adjust the cutting height.
IMPORTANT: Please use the height adjust dial with
gauge wheel. Raise the mower deck to its
maximum before operating this dial.
ZERO TURN MOWER
Summary of Contents for SZ330
