Iseki SZ330, Operation Manual

Page: 58 / 96

57
e. Remove the oil filler cap,1, from top of the cylinder
head cover,2, and pour in fresh engine oil turough the
oil filler. Be sure to use oil recommended by ISEKI.
Refer to " 1. ENGINE OIL LEVEL ".
Engine oil capacity: 4.5 litres (0.99 imp.gal)
f. After engine oil replacement, start the engine and let it
idle for a while.
g. Then stop it and wait for a while until the engine oil
comes down into the oil pan. Now check the oil level
to check to see if it is at the upper limit or not. When
the level is low, replenish until the level reaches the
upper limit.
IMPORTANT: Never fill over the upper limit, or it may
cause engine trouble.
h. Make sure that there is no oil leakage through the
drain plug and oil filter.
18. ENGINE OIL FILTER REPLACEMENT
IMPORTANT:
•
The engine oil filter should be replaced after the initial
50 hours of operation and then after every 300 hours
of operation.
• It is recommended to ask your dealer to replace the
engine oil filter, because this operation requires a spe-
cial tool. But when there is no alternative but to
replace the filter by yourself, observe following instruc-
tions.
a. Drain engine oil completely following the instructions
of "17. ENGINE OIL REPLACEMENT."
b. Place some rags under the engine oil filter to receive
dripping oil when the filter is replaced. The engine oil
filter is located on the Left-hand wall of the cylinder
block.
c. Loosen the filter using a filter spanner and remove it.
d. Install a new filter with the O-ring lubricated with fresh
engine oil. Screw in the filter until its packing comes
into contact with the sealing surface of the engine and
then tighten it by a 2/3 turn with the filter spanner.
e. Pour the drained oil back in referring to ’’17 ENGINE
OIL REPLACEMENT."
(1) Cylinder head cover (2) Filler cap
(1) Engine oil filter
CHAPTER 8. MAINTENANCE
2
1
1
FIG. 71
FIG. 72