Kwik-Way
SVS II Deluxe Valve Refacer
Copyright © 2018 by Irontite Products Inc.
All Rights Reserved. Rev. 180802
pg. 24
CLEANING
CLEANING THE CHUCK (Chuck Disassembly)
WARNING:
Disconnect the machine from its power source
before cleaning the chuck.
The Valve Chuck Disassembly / Assembly Tool is required
to perform the following procedures.
1)
Remove the chuck cover from
the Chuck Bearing Assembly,
being careful not to pull any
wires from the cover.. Rotate the
Chuck so that the Grind Mark on
the front collar and the Yellow
Mark on the Spring are Vertical
as show in the photo left.
2)
Remove the (3) three
8 x 32 x 5/16 slot head screws
from the Chuck End Cap (Black)
shown right.
3)
Use the Disassembly Tool
(picture at the top) that comes
with your machine, put the 8 x
32 screws (3) into the chuck
shaft in a 1/4 of an inch. Put the
1/4 x 20 Hex Head Bolt finger
tight against the End Plate.
4)
Remove the Chuck Yoke
5)
Loosen the 1/4 x 20 Hex head
bolt counter clockwise. As you
release the 1/4 x 20 bolt, the
spring pressure should begin to
release.. NOTE: You may need
to soak the chuck in Automatic
Transmission Fluid to remove
grit and make the collars slide
easier.
6)
Remove the Chuck Disassembly
Tool.
7)
Begin to remove the outer collar
from the chuck shaft. Next,
remove the Loading Cup with
the Four (4) springs. The large
spring and inner collar will be
removed along with the Thrust
Step Washer. As you take the
Inner collar off the steel chuck
balls (9/16) may fall out of the
chuck shaft.
8)
Remove the Chuck Hand wheel
and belt from the chuck shaft.
Remove the chuck from the
chuck bearing assembly. Clean
all parts with a parts cleaning
solvent.
