Kwik-Way
SVS II Deluxe Valve Refacer
Copyright © 2018 by Irontite Products Inc.
All Rights Reserved. Rev. 180802
pg. 15
PRECAUTIONS WHEN DRESSING THE WHEEL
1. Take very light cuts, heavy cuts may grind away the mounting and loosen the diamond.
2. Avoid shocks or blows to the diamond tool.
3. The diamond and tool must be locked firmly and the wheel fed gradually across the diamond point.
4. Be careful not to jam the wheel into the diamond.
DRESSING THE STEM WHEEL (SEE FIGURE 6)
The stem wheel needs to be dressed periodically to maintain a sharp cutting edge and clean face.
1. Depress the right side of the rocker switch (spindle) and move the traverse handle to the left until
the spindle motor comes on.
2. Leave the spindle slide in this location and turn the motor off (center position on the main switch).
3. Loosen the adjustable spindle slide stop, move it up tight against the fixed stop and tighten it to
prevent the spindle slide from moving while dressing the stem wheel.
4. Install the round diamond in the V-block and clamp it in place.
5. Using the micrometer feed, move the diamond point in until it just touches the stem wheel.
6. Move the diamond clear of the wheel and turn the main switch to the spindle “ON” position.
NOTE: Coolant must always be directed onto the diamond when dressing.
7. Sweep the diamond across the face of the wheel feeding in .003 to .005 until the face has been
totally cleaned up.
Figure 6
