Kwik-Way
SVS II Deluxe Valve Refacer
Copyright © 2018 by Irontite Products Inc.
All Rights Reserved. Rev. 180802
pg. 27
MAINTENANCE
Your
KWIK-WAY SVS II Deluxe
Valve Facing Machine is designed as a minimal maintenance product.
However, some basic maintenance will assure that it will continue to operate in a satisfactory manner.
LUBRICATION
1. Grinder spindle slide ways are equipped with snap-lid oilers (1 front, 1 rear) and must be oiled
once a week (more frequently if machine is in continuous service).
2. Chuck slide feed screw is equipped with a snap-lid oiler located near the hand wheel.
3. Gib and dovetail ways have two (2) snap-lid oilers, one behind the chuck motor and the other
under the chuck shaft and between the chuck bearings.
4. Spindle drive motor has two oiling points, one at each end. USE ONLY A FEW DROPS OF OIL
in each (every 3 to 4 months).
CAUTION:
Excessive oiling will damage the motor.
5. The crankshaft assembly, chuck motor and gear case are all lubricated for life and require no
additional lubrication.
6.
Surface grinding attachment requires only a few drops of oil placed on either side of the V-block
on a weekly basis.
The Chuck Collar Area -
This area
should only be lubricated with Automatic Transmission Fluid
.
Use a spray bottle and use sparingly. If you notice the chuck opening and closing slowly or in a sticky
motion use
a little ATF spray
and actuate the open can close switch several times to spread the
lubrication.
DO NOT USE WD-40 or any other SPRAY LUBRICANTS or PENETRATING OILS. NO
BRAKE OR CARB CLEANER EITHER!
Valve Slide Feed Hand Wheel Adjustment
– If you valve slide has too much play you adjust it by turning
the hand wheel so the set screw is visible, then turn it one full rotation clockwise, loosen the set screw
and push inward on the hand wheel then tighten the set screw.
Grinding coolant should be changed as needed when it gets dirty. Use only Kwik-Way Grinding Coolant
P/N: 000-2112-73 and Kwik-Way formula grinding stones for best results. Use of other Coolant will
significantly affect the performance of the machine and void the warranty.
Always cover the chuck with a shop towel when dressing your grinding stone to keep debris from entering
the chuck collar area. Never direct your coolant nozzle into or over the chuck as this can introduce debris
into your chuck and cause it to wear prematurely.
